Protector Controlled Atmosphere Glove Boxes

These glove boxes, available with either fiberglass or stainless steel liners, provide a leak-tight environment to perform work with contamination-sensitive materials.

Features
• Factory leak-tested with a mass spectrometer while pressurized with helium at 5 inches of water gauge. No detectable leaks greater than 1 x 10-6 ml/sec.
• Exceed Class I atmosphere containment conditions for oxygen permeation <1.67 ppm/min per ISO 10648-2 test method. • Oxygen permeation <0.3 ppm/min (fiberglass-lined models) and <0.15 ppm/min (stainless steel-lined models) per ISO 10648-2. • Four manual valves – two on the main chamber and two on the transfer chamber – for evacuating, filling and added control. With 3/8” compression fittings and 3/8” hose barbs. • Factory-installed, rear-mounted, low profile stainless steel pressure relief bubbler at ±6 inches of water gauge. • Two rear-mounted inlet and oulet 3/4” OD compression fittings for easy connection to optional AtmosPure Re-Gen Gas Purifier or other accessory drying train. • Large viewing area, 36” w x 27.6” high, provides maximum visibility. Viewing window is 3/8” thick, laminated safety glass. • Space-saving inner and outer transfer chamber doors that pivot upward, are counterbalanced and equipped with quick-latches. • Interior right-hand side wall-mounted electrical duplex receptacle rated to 5 amp maximum (100/115 volt models) or 3 amp maximum (230 volt models) circuit load • Interior left-hand side wall-mounted pass through plug for on-site installation of an optional accessory: electrical outlet, RS-232 port, gas/liquid port, or port for oxygen or moisture monitor. • Pair of neoprene gloves, 0.015” thick, 30” long, size 9 ¾. • Switches for light, blower and electrical duplex. • Two 8” ID, epoxy-coated aluminum double-grooved glove ports mounted 17” apart, with neoprene gaskets. • Two 25-watt fluorescent lights. • Dry-powder epoxy-coated, 18 and 20 gauge steel exterior panels. Options • Chemical resistant, one-piece molded fiberglass liner or type 304 stainless steel liner • Clear acrylic inner and outer transfer chamber doors (fiberglass-lined models). • Type 304 stainless steel inner and outer transfer chamber doors and front panel (stainless steel-lined models). • Main chamber pressure analog gauge with readings from -5 to +5 inches of water gauge (basic models). • Transfer chamber pressure analog gauge with readings from 0 to 29.5 inches of mercury (basic models). • Automatic Pressure Controller controls main chamber pressure (-5 to +5 inches of water gauge), main chamber evacuation and filling cycles (up to 499 cycles) and transfer chamber evacuation and filling cycles (up to 499 cycles) (auto pressure control models). • Mutable, audible alarm that sounds when pressure/vacuum level is outside set limits (auto pressure control models). • LCD display of main chamber and transfer chamber pressure in inches of water, inches of mercury and mBar (auto pressure control models). • Three-position foot pedal (increase gas/fill, off, evacuate/decrease gas) (auto pressure control models). • Input/output port for optional AtmosPure Re-Gen Gas Purifier (auto pressure control models). • Protector Stainless Steel Double Filtered Glove Boxes have 81.84” of interior working width and four glove ports • International electrical configuration Required Accessories • Adjustable Height Base Stands • Vacuum source • Inert gas for filling Optional Accessories • AtmosPure Re-Gen Gas Purifier